Ice Maker And Storage Bin; Turning The Ice Maker On/Off; Removing And Replacing The Ice Storage Bin - IKEA P9WB2L Manual De Instrucciones Para El Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

7. Twist the water filter and turn 90° clockwise until it locks into
place and the arrows are aligned.
8. Push the water filter door closed.

Ice Maker and Storage Bin

Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced.
The quality of your ice will be only as good as the quality of
the water supplied to your ice maker. Avoid connecting the ice
maker to a softened water supply. Water softener chemicals
(such as salt) can damage parts of the ice maker and lead to
poor quality ice. If a softened water supply cannot be avoided,
make sure the water softener is operating properly and is well
maintained.
Do not use anything sharp to break up the ice in the storage
bin. This can cause damage to the ice container and the
dispenser mechanism.
Do not store anything on top of or in the ice maker or
storage bin.

Turning the Ice Maker On/Off

Style 1
To turn on the ice maker, lift open the ice maker door and
lower the wire shut-off arm to the On (down) position.
To manually turn off the ice maker, lift the wire shut-off arm
to the Off (up) position and listen for the click. Ice can still be
dispensed, but no more can be made.
NOTE: Your ice maker has an automatic shut-off. As ice is made,
the ice cubes will fill the ice storage bin, and the ice cubes will
raise the wire shut-off arm to the Off (up) position. Do not force
the wire shut-off arm up or down.
14
Style 2
The On/Off switch is located on the bottom of the Ice Maker. It
can be accessed by lifting and opening the ice make door.
To turn on the ice maker, lift open the ice maker door and flip
the switch to the On (right) position.
To manually turn off the ice maker, lift open the ice maker door
and flip the switch to the Off (left) position. Ice can still be
dispensed, but no more can be made.
NOTE: Your ice maker has an automatic shut-off to keep the
storage bin from overfilling during normal operation. As ice is
made, the ice cubes will fill the storage bin, and the ice cubes will
raise the shut-off arm to the Off (up) position. When the storage
bin is at full capacity, the ice maker will automatically stop ice
production, but the ice maker On/Off switch will remain in the
On (right) position.

Removing and Replacing the Ice Storage Bin

1. Lift and hold open the ice maker door.
2. Lift the wire shut-off arm so it clicks into the Off (up) position,
or flip the switch to the Off (left) position. Release the ice
maker door.
3. Lift up the front of the storage bin and pull it out.
4. Replace the bin by pushing it in all the way, or the dispenser
will not work.
5. To restart ice production, lift open the ice maker door and
push the wire shut-off arm to the On (down) position or flip the
switch to the On (right) position. Make sure the door is closed
tightly.

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

P9rfwb2l

Tabla de contenido