Instructions For Putting Into Operation; General; Mobile Headlight Aiming Devices Efle 50, Efle 51, Efle 60 And - Bosch EFLE 50 Instrucciones De Manejo

ENGLISH

Instructions for putting into operation

Before the headlight aiming device is put into initial operation the
alignment mirror and the handle on EFLE 50, 51, 60 and 61 must
be turned to the working position.
Operations required to do this
Release the locking screw (1) on the equipment support
column using a 4 mm hexagon-socket screw key.
Swing the arm holding the alignment mirror 180° upward (2).
Tighten the locking screw again.
Fig. 1
Operations required to do this
Release the locking screw (1) on the equipment support
column using a 5 mm hexagon-socket screw key.
Swing the handle 90° outwards.
Insert the locking screw in the hole and tighten.
Fig. 1a
1 689 979 219 07.06.05
1.

General

Headlamps on motor vehicles must not blind the drivers of
vehicles coming from the opposite direction. The inclination and
the aiming of the headlamp light beam to the side must therefore
be adjusted according to legal specifications.
In order to make these legally specified adjustments of motor-
vehicle headlamps, Bosch supplies the following aiming devices:
1.1 Mobile headlight aiming devices
EFLE 50, EFLE 51, EFLE 60 and 61
! The surface on which the headlight aiming device is set
up must be even but it does not have to be horizontal.
In order to achieve the specified measurement accuracy,
surface irregularities within the area where the aiming
device is used must be less than 1.2 mm.
Fig. 2
1 alignment mirror
2 handle
3 luxmeter
4 deflection mirror
5 markings for lens center
9