Operating Instructions; Tire Demounting; Preparations For Demounting - Bosch TCE 4460 Manual Del Usuario

en 34 | TCE 4460 | Operating instructions
5.

Operating instructions

Warning - tire or rim damage danger!
Excessive pressure can e. g. result in cracks
(on the inside/outside) of the tire. The rim
can be scratched or deformed.
€
Read the Wdk publications available in
German and English! (www.wdk.de: moun-
ting/demounting instructions – criteria
catalogue)
€
Inner temperature of the tire must be at
least 15 °C (only in case of RFT/UHP).
€
Read the Wdk publications available
in German and English! (www.wdk.de:
mounting/demounting instructions – tire
overheating)
€
Adjust pressure to the type of tire.
€
Use the plastic protections on the types of
rim that need it.
!
Before demounting or mounting operations it is ext-
remely important to collect all the rim and tire data.
In this way it will be possible to know in advance the
mounting, the pressure and the required accesso-
ries!
i
Remove all the balancing weights from the rim.
i
If the semi drop centre of the rim is placed in the
inside part it is necessary to insert a cover to the
locking jaws (see chap. 3.3) on the flanged plate,
because in this case the rim leans on its side during
rotation.
|
1 695 105 428 2010-02-16
5.1

Tire demounting

i
Read the Wdk publications available in German and
English!
(www.wdk.de: mounting/demounting instructions).
5.1.1

Preparations for demounting

!
Avoid valve damage!
1. Pull out the needle from the valve.
« The air is discharged completely from the tire.
i
Before starting tire bead breaking operations, set
the position of the 3 positions device (1) and of the
bead breaker blade (2) depending on the width of
the tire.
Robert Bosch GmbH