Switching Off The J93 Clamp - Chauvin Arnoux J93 Manual De Instrucciones

„ Open the jaws of the clamp by moving the arm closer.
„ Clamp the conductor carrying the current to be measured. There must be only one conductor in the jaws of the clamp.
„ Gently close the jaws. In order to optimize measurement quality, centre the conductor as accurately as possible in the jaws.
„ Read the measurement on the device.
„ When the measurement is over, open the clamp and withdraw the conductor. Then disconnect the clamp from the device.
„ Switch off the device.

2.3. SWITCHING OFF THE J93 CLAMP

„ Set the switch to OFF.
ZERO
ON
OFF
300 V CA T IV
600 V CA T III
21