Charging The Battery - Chauvin Arnoux PEL51 Guia De Inicio Rapido

SD CARD
The PEL accepts SD, SDHC and SDXC cards formatted FAT32, up to 32 GB capacity.
The PEL is delivered with a formatted SD card. If you want to install a new SD card:
Unlock the elastomeric cap marked
„
Press the SD card that is in the device then remove it.
„
Do not remove the SD card if there is a recording in progress.
Check that the new SD card is not locked.
„
It is preferable to format the SD card in the device using PEL Transfer software, otherwise format it using a PC.
„
Insert the new card and press it in all the way.
„
Replace the elastomeric protective cap.
„
The PEL must not be used when the SD card slot is open.

CHARGING THE BATTERY

Before first use, first fully charge the battery at a temperature between
0 and 40°C.
Connect the C8 / banana adapter between the V1 and N terminals
„
Plug the power cord into the adapter and mains power.
„
The device turns on.
The symbol indicates the battery state of charge.
It takes about 5 hours to charge a discharged battery.
by turning the screw a quarter turn.
90 ... 690 V
50 ... 60 Hz
PEL 52
POWER & ENERGY LOGGER