Description Of Symbols - Triton TMUTL Instrucciones De Uso

Introduction
Thank you for purchasing this Triton tool. This manual contains information necessary
for safe and effective operation of this product. This product has unique features and,
even if you are familiar with similar products, it is necessary to read this manual
carefully to ensure you fully understand the instructions. Ensure all users of the tool
read and fully understand this manual.

Description of Symbols

The rating plate on your tool may show symbols. These represent important information about
the product or instructions on its use.
Wear hearing protection
Wear eye protection
Wear breathing protection
Wear head protection
Wear hand protection
Read instruction manual
Caution!
WARNING: Moving parts can cause crush and cut injuries
Toxic fumes or gases!
Indoors use only
Class II construction (double insulated for additional protection)
T3.15A
Internal time-lag fuse with rated current 3.15A
Conforms to relevant legislation and safety standards
Environmental Protection
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authority or retailer
for recycling advice
6
Original Instructions
Technical Abbreviations Key
V
~, AC
A, mA
n
0
n
opm
°
Hz
DC
W, kW
/min or min
rpm
dB(A)
m/s
2
Ø
Specification
Model number
Input voltage
Power
No load speed
Oscillating arc range
Protection class
Ingress protection
Dimensions (L x W x H)
Weight
Sound and vibration information
Sound pressure L
Sound power L
Uncertainty K
Weighted vibration a
Uncertainty K
The sound intensity level for the operator may exceed 85dB(A) and sound protection
measures are necessary.
As part of our ongoing development, specifications of TRITON products may alter
without notice.
The declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another. The declared vibration total
value may also be used in a preliminary assessment of exposure.
WARNING: The vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used. There is the need to
identify safety measures to protect the operator that are based on an estimation of exposure
in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
WARNING: Always wear ear protection where the sound level exceeds 85dB(A) and limit the
time of exposure if necessary. If sound levels are uncomfortable, even with ear protection, stop
using the tool immediately and check the ear protection is correctly fitted and provides the
correct level of sound attenuation for the level of sound produced by your tool.
Volts
Alternating current
Ampere
No load speed
Rated speed
Orbits or oscillations per minute
Degrees
Hertz
Direct current
Watt, kilowatt
-1 Operations per minute
Revolutions per minute
Decibel sound level (A weighted)
Metres per second squared
(vibration magnitude)
Diameter
TMUTL
120V~ 60Hz
2.5A
11,000–21,000min
3.2°
IP20
2-7/16 x 3-15/16 x 11"
3.7lb
80dB(A)
PA
91dB(A)
WA
3dB(A)
3.68m/s
h
1.5m/s
-1
2
2