MSA Latchways PRD Manual Del Usuario página 10

EN
Pre-use checks
Descent device/line (continued)
Figure 6
Figure 7
Figure 8
Figure 9
10
• Inspect descent line for any 'slack' between the drum and
rack (Figure 6). If the line is slack the Latchways PRD shall be
removed from service and advice sought from Latchways or
authorised agent.
• Check the legibility of the product markings.
• Inspect the release pin for signs of damage, distortion, corrosion
or cracking. Ensure that it is engaged. Ensure that the red release
cord is positioned under the release pin and that the load-line
webbing is looped around the release pin (Figure 7).
• Ensure that the green release pin clip is present and undamaged—
check for signs of damage, distortion or cracking (Figure 7).
• Ensure that the release cord guide is undamaged (Figure 8).
• Inspect the descent line, load-line and release cord for signs of cuts,
abrasion, fraying, tears, mould, discolouration, chemical attack or
excessive build-up of dirt. Check the stitching for signs of loosening,
pulling or cut thread. Excessive build-up of dirt may prevent the
descent line from pulling through the device. If damage is apparent
the Latchways PRD shall be removed from service and advice
sought from Latchways or authorised agent.
• After inspection close the zip on the backpack fully.
• Unzip the back panel of the backpack and inspect the harness
connector for signs of damage, distortion, corrosion or cracking.
Ensure that the fastening bolt is secure (Figure 9). If damage is
apparent or the bolt insecure the Latchways PRD shall be removed
from service and advice sought from Latchways or authorised
agent.
• Inspect all system components and subsystems according to
Latchways' instructions.