MSA Latchways PRD Manual Del Usuario página 12

EN
Using the Latchways PRD
Fitting and adjusting the harness (continued)
Figure 13
Figure 14
Figure 15
Figure 16
12
Note: If adjustment of the shoulder straps is required, remove the
harness and undo the zips on either side of the backpack(Figure
13). Adjust the shoulder straps by sliding the shoulder strap
adjustment buckles and cross strap buckle (where the shoulder
straps cross). Check adjustment by continuing to try on the harness
until the chest strap and connection point are correctly positioned.
• Connect the leg buckles
pulling the straps through the buckles to achieve a snug fit (Figure
14).
• Where included (RH3 harness only), connect the waist belt buckle at
the front, and adjust the strap by pulling the strap through the buckle
to achieve a snug fit (Figure 15).
• Use the plastic sliders to secure any free strap. (Figure 16).
(B) (Figure 11). Adjust the leg strap by