ABB Totalflow NGC8206 Manual Del Usuario página 250

TERM
Amp
Ampere
Ampere-Hour
Ampere-Hour Efficiency
Amplifier
Amplitude
Amplitude Modulation
Amplitude Span
AMU
AMU/IMV
Analog
Analog Input
Analog Measurement
Unit
Analog Output
Analog Trigger
Analog-to-Digital
Converter
Analytical Module
Página B–4
See Ampere.
The unit of electrical current. Also milliamp (one thousandth of an amp)
and micro amp (one millionth of an amp). One amp corresponds to the
18
flow of about 6 x 10 electrons per second.
The quantity of electricity measured in ampere-hours (Ah) which may
be delivered by a cell or battery under specified conditions. A current of
one ampere flowing for one hour.
The ratio of the output of a secondary cell or battery, measured in
ampere-hours, to the input required to restore the initial state of charge,
under specified conditions.
A device which draws power from a source other than the input signal
and which produces as an output an enlarged reproduction of the
essential features of its input.
The highest value reached by voltage, current or power during a
complete cycle.
Where audio signals increase and decrease the amplitude of the
"carrier wave".
The Y-axis range of a graphic display of data in either the time or
frequency domain. Usually a log display (dB) but can also be linear.
See Analog Measurement Unit.
Generic reference to the Measurement unit. See Analog Measurement
Unit and Integral Multivariable Transducer for more definition.
A system in which data is represented as a continuously varying
voltage/current.
Data received as varying voltage/current.
A transducer for converting energy from one form to another. (e.g.
Static and Differential pressure to electrical signals)
A voltage or current signal that is a continuous function of the
measured parameter. Data that is transmitted as varying
voltage/current.
A trigger that occurs at a user-selected point on an incoming analog
signal. Triggering can be set to occur at a specific level on either an
increasing or a decreasing signal (positive or negative slope).
An electronic device, often an integrated circuit, that converts an analog
voltage to a number.
The primary component of the NGC8200's modular design is the
analytical module. This module comes in a 12VDC or a 24VDC
configuration and contains the GC Module, Analytical Processing
system and manifold. Replacement of this component is enhanced by
the single bolt removal feature. This module may also be broken down
into the GC module, manifold assembly and analytical processor
assembly.
DEFINITION
2103650-001 – rev. AB