ABB Totalflow NGC8206 Manual Del Usuario página 261

TERM
Compressed Gas
Compressed Natural
Gas
Compressibility
Compressibility Factor
Compressibility Factor
Concentration
Concurrent
Condensate
Condensation
Condensed Phases
Condensed States
Conduction
Configuration No.
Console Mode
Contact
Conversion Time
2103650-001 – rev. AB
A gas or mixture of gases having, in a container an absolute pressure
exceeding 40 psi at 21.1°C (70°F). A gas or mixture having in a
container, an absolute pressure exceeding 104 psi at 54.4°C (130°F)
regardless of the pressure at (21.1°C (70°F). A liquid having a vapor
pressure exceeding 40 psi at 37.8°C (70°F) as determined by ASTM D-
323-72.
Natural gas in high-pressure surface containers that is highly
compressed (though not to the point of liquefaction). CNG is used
extensively as a transportation fuel for automobiles, trucks and buses in
some parts of the world. Small amounts of natural gas are also
transported overland in high-pressure containers.
The property of a material which permits it to decrease in volume when
subjected to an increase in pressure. In gas-measurement usage, the
compressibility factor "Z" is the deviation from the ideal Boyle and
Charles' law behavior. See SUPERCOMPRESSIBILITY FACTOR.
See Supercompressibility Factor.
A factor usually expressed as "z" which gives the ratio of the actual
volume of gas at a given temperature and pressure to the volume of
gas when calculated by the ideal gas law without any consideration of
the compressibility factor.
Amount of solute per unit volume or mass of solvent or of solution.
Performing more than one task at a time.
1) The liquid formed by the condensation of a vapor or gas; specifically,
the hydrocarbon liquid separated from natural gas because of changes
in temperature and pressure when the gas from the reservoir was
delivered to the surface separators. 2) A term used to describe light
liquid hydrocarbons separated from crude oil after production and sold
separately.
Liquefaction of vapor.
The liquid and solid phases; phases in which particles interact strongly.
The solid and liquid states.
The conveying of electrical energy or heat through or by means of a
conductor.
The Configuration number is a suffix of the serial number which defines
the characteristics of the unit.
A local user interface typically used with custom applications that are
not supported through any other mechanism. Also referred to as Printer
Console Mode.
Current carrying part of a switch, relay or connector.
The time required, in an analog input or output system, from the
moment a channel is interrogated (such as with a read instruction) to
the moment that accurate data is available. This could include switching
time, settling time, acquisition time, A/D conversion time, etc.
DEFINITION
Página B–15