Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
ASSEMBLY AND OPERATION
APPLICATIONS
Cutting metal and stainless steel pipe.
Cutting various lumber.
Cutting mild steel, aluminum and copper plate.
Cutting synthetic resins, such as phenol resin and vinyl chloride.
REMOVAL AND INSTALLATION METHOD OF BATTERY
CAUTION: Be sure to keep the switch turned off and the lock-off button moved to
right position (lock position). (See Fig. 23)
Handle
Insert
Pull out
Fig. 4
CHARGING METHOD
NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
14
Switch trigger
Latch
Battery
Push
Do not charge at voltage higher than indicated on the
nameplate.
If charged at voltage higher than indicated on the nameplate,
the charger will burn out.
How to install the battery.
Align the battery with the groove in tool
handle and slip it into place.
Always insert it all the way until it locks in
place with a little click. If not, it may acci-
dentally fall out of the tool, causing injury
to you or someone around you. (Fig. 4)
How to remove the battery.
Withdraw battery from the tool handle while
pressing the latches (2 pcs.) on the sides of
the battery. (Fig. 4)
Publicidad
Tabla de contenido
