Using Magicwatch; Maintaining And Cleaning Magicwatch - Waeco MagicWatch MWE250 Instrucciones De Montaje

MWE-250-3.book Seite 39 Dienstag, 28. März 2006 4:50 16
MagicWatch MWE250
8

Using MagicWatch

MagicWatch is activated automatically when you engage reverse gear with
the ignition on or the motor running.
As soon as there is an obstacle within the detection range, a repeated signal
tone sounds. As you reverse, the sequence of beeps changes according to
the zone you are in (see "Testing functions"chapter on page 38"), thus indi-
cating the distance.
Be very careful the first time you use the system, until you are familiar with
the various sequences of beeps.
Caution!
Stop the vehicle immediately and check the situation (getting out if
necessary), if the following happens while you are reversing:
The device first shows an obstacle while you reverse, and the
beeps speed up as normal (i.e. from slow to medium). Suddenly
the beeps become slow again or no obstacle at all is shown.
This means that the original obstacle is in the blind spot of the sen-
sors (depending on the design), and you might hit it.
9

Maintaining and cleaning MagicWatch

Caution!
Do not use sharp or hard objects to clean the device as these may
damage the sensors.
➤ Clean the sensors with a damp cloth from time to time.
Using MagicWatch
39