Installing Magicwatch; Tools Required - Waeco MagicWatch MWE250 Instrucciones De Montaje

MWE-250-3.book Seite 33 Dienstag, 28. März 2006 4:50 16
MagicWatch MWE250
Caution!
As these four examples show, situations can arise where the
device fails to display an object or does not display the shortest
distance.
The device does not relieve you of your obligation to take special
care when reversing. Therefore, always be extremely careful
when reversing.
If an object enters the blind spot of the sensors, MagicWatch auto-
matically shows the distance to the next object. This means the pie-
zoelectronic speaker changes from fast to medium beeps.
In this case, always stop the vehicle immediately and check the sit-
uation.
6

Installing MagicWatch

6.1

Tools required

For installation and assembly you require the following tools:
Drill bit set (see fig. 1.1, page 3)
Drill (see fig. 1.2, page 3)
Screwdriver (see fig. 1.3, page 3)
Set of ring or open-ended spanners (see fig. 1.4, page 3)
For making and testing the electrical connection the following tools are
required:
Diode test lamp (see fig. 1.5, page 3) or Voltmeter (see fig. 1.6, page 3)
Crimping tool (see fig. 1.7, page 3)
Insulating tape (see fig. 1.8, page 3)
Cable bushing sleeves, if required
To secure the controller and the cable you may require additional screws
and cable binders.
Installing MagicWatch
33