Avertissements - Inglesina carrycot 3P Manual De Instrucciones

LIST OF COMPONENTS
A
3-point safety harness
B
Connection devices
C
Shock absorbing cushion
FASTENING THE SAFETY HARNESS
The 3-point safety harness (A) must be fastened to the
bottom of the carrycot.
Ensuring that the head support of the carrycot is
(D) of the harness in the dedicated holes on the carrycot's
plastic base, passing through the internal lining (E).
Complete the fastening, inserting the loops of the
crotch strap (F) into the hole at the bottom of the carrycot,
Place the loops of the crotch strap (F into their
POSITIONING THE SHOCK ABSORBING CUSHION
The shock absorbing cushion (C) must be placed
beneath the internal lining of the carrycot.
Place the cushion properly at the bottom, making
sure it adheres to the back of the structure.
PREPARING THE VEHICLE SAFETY BELTS
Fasten both safety belts of the rear seat in the
vehicle (H), making sure there is sufficient space for the
carrycot to fit in.
loosen them.
Engage the connection devices (B) making sure
that the red lever (I) is open.
Insert a section of the eyelet of the lumbar part
of the car's seat belt through the metal ring of one of the
connection devices (B).
Rotate the red lever (I) and insert it into the slot of
the vehicle's safety belt.
LISEZ
CES INSTRUCTIONS
D'UTILISER
CONSERVEZ-LES BIEN POUR
TOUTE AUTRE CONSULTATION.
NE PAS TENIR COMPTE DES MISES EN
GARDE ET DES INSTRUCTIONS FOURNIES
PEUT S'AVÉRER TRÈS DANGEREUX POUR
VOTRE ENFANT.
VOUS ÊTES RESPONSABLE DE LA SÉCURITÉ
16
INSTRUCTION
D) into their housings on the
E).

AVERTISSEMENTS

ATTENTIVEMENT
AVANT
CE PRODUIT.
Lock the connection device (B) by pulling the
diagonal section of the seat belt of the car.
When necessary, move the connection device
(B) by lifting the eyelet of the car seat belt to make it slide.
Complete the operation repeating the instructions above for
the other seat belt.
FASTENING THE CARRYCOT
Place the carrycot on the rear seat of the vehicle.
To engage the connection devices (B) push them
against the carrycot pegs (K) until they click in position.
To remove the carrycot from the seat, pull the red
lever (L) and push the connection device (B
fully released.
POSITIONING THE BABY INTO THE CARRYCOT
Place the baby in the carrycot, buckle (M) up the
3-point harness.
Release it by pressing the red button on the first
O
To release the harness, press the red button on the
buckle (M).
REMOVING/HOUSING THE RESTRAINT SYSTEM WHEN
NOT IN USE
strap assembly or place them in the dedicated side pockets if
the continuous surveillance of an adult.
DE VOTRE ENFANT.
AVERTISSEMENT!
L'ENFANT SANS GARDE: CELA PEUT
ÊTRE DANGEREUX. FAIRE LE MAXIMUM
D'ATTENTION LORSQU'ON UTILISE LE
PRODUIT.
AVERTISSEMENT!
D'ÉTRANGLEMENT. NE JAMAIS LAISSER
L'ENFANT SANS SURVEILLANCE. NE JAMAIS
LAISSER L'ENFANT DANS LA NACELLE SANS
K) that are easily reached
N).
NE PAS LAISSER
DANGER