Troubleshooting - Briggs & Stratton 3500 WATT Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

TROUBLESHOOTING

Problem
Engine is running, but no AC
output is available.
Engine runs good but bogs down
when loads are connected.
Engine will not start; or starts and
runs rough.
Engine shuts down during
operation.
Engine lacks power.
3500 Watt Portable Generator
Cause
1.
Circuit breaker is open.
2. Poor connection or defective
cord set.
3. Connected device is bad.
4. Fault in generator.
1.
Short circuit in a connected
load.
2. Generator is overloaded.
3. Shorted generator circuit.
1.
Out of fuel.
2. Fuel valve is in the "Closed"
position.
3. Low oil level.
1.
Out of fuel.
2. Low oil level.
Load is too high.
www.mymowerparts.com
Solution
1.
Reset circuit breaker.
2. Check and repair.
3. Connect another device that is
in good condition.
4. Contact Briggs and Stratton
service facility.
1.
Disconnect shorted electrical
load.
2. See "Don't Overload Generator".
3. Contact Briggs and Stratton
service facility.
1.
Fill fuel tank.
2. Turn fuel valve to the "Open"
position.
3. Fill crankcase to proper level.
1.
Fill fuel tank.
2. Fill crankcase to proper level.
See "Don't Overload Generator".
14

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido