Installation And Connection - Pontec PondoClear Set 4000 Instrucciones De Uso

Ocultar thumbs Ver también para PondoClear Set 4000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
- EN -
Fit filter
How to proceed:
5 C
1. Take kit, hose and submersion unit out of the container and place aside.
2. Insert the inlet bend through the inlet opening, then align with the container bottom.
3. Screw a hose connector from the kit on to the inlet bend at the outside of the container.
– The union nut of the hose connector must have an O ring. Insert, if necessary.
4. Close the container. (® Installation)
Connect the submersion unit to the filter
How to proceed:
1. Screw a hose connector from the kit on to the outlet of the submersion unit.
2. Push the hose ends up to the hose connector stop of both units.

Installation and connection

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
· Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
· Isolate the device (disconnect from the power supply) before carrying out any work on it.
How to proceed:
5 D, E
1. Place the submersion unit on level ground in the pond, and install the filter at the pond bank.
– Note the maximum submersion depth of the submersion unit.
– The filter can stand freely or can be buried up to half of its height as a maximum.
– Recommendation: The filter outlet points to the pond.
2. Return the water into the pond and ensure a sufficient hose gradient.
– A DN 50 HT tube system or 2" hoses can be used to return the water into the pond.
– On the unit side, the tube is pushed into the outlet or the 2" hose is fastened to the outlet using a hose clip.
3. Prepare the electrical connection.
– Route the connection tubes/hoses safely. (® Safety information)
Operation
W A R N I N G
Death or serious injuries from hazardous electrical voltage due to operation of this unit in a swimming pond.
· Never operate this unit in a swimming pond.
This is how to connect the power supply:
Switching on: Connect the unit to the mains. The unit switches on immediately.
Switching off: Disconnect the unit from the mains.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido