NSK Varios 970 Operación Manual página 6

Operation Panel and Display
Operation Mode
Display
Numerical Display
If you purchase the Optional products such as Water Tube and Water Connector you can use Tap Water.
Mode Select Keys
You can select Operation Mode to pressing this key. (Perio, Endo and General) The Control Unit can resume power level,
water volume and irrigation mode for each Operation Mode.
Power Level Keys
Press key to select Power o/p Level . There are  levels (0 to 0). There
is no output vibration at level 0 (zero). (Fig.). The Bar Graph Indicator and
Numerical Display will change simultaneously.
Irrigation Select Key
Press key to select 'R' or 'L' Bottle. Front panel display and Bottle Selection Indicator simultaneously change in position.
Pressing the Irrigation Select Key for more than one second will select Tap Water Mode.
Auto-Cleaning Key
Press key to select Auto Cleaning Mode, For detail refer to . (4).
Bottle Water Adjustment Knob
Water Volume Adjustment can be made prior to the tip vibrating
you can adjust the Water Volume during Bottle Irrigation or
during a wait before Tip vibration start. If the setting is not
applicable (too low or too high) for the Control Unit, it may beep.
During the operation, Front Panel displays the current Power
Level. However, keep turning the knob more than a second; it
may change the Water Volume.
Mode Select Keys
Endo Key
Perio Key General Key
Power Level Keys
Down Key
Irrigation Select Key
Up Key
CAUTION
• Do not turn the knob fast. It may not sense
the movement if it turn fast.
• Water Volume can set during 5ml/min to
45ml/min.
• Operation sound may different between
Right and Left Bottle.
• During adjustment of water volume,
Numerical Display indicate "–".
5
Auto-cleaning Key
Irrigation Mode
Display
Bar Graph Indicator
Fig.