Parts Description; Bench Mounting; Functional Description; Installing Or Removing Battery Cartridge - Makita DLS714 Manual De Instrucciones

PARTS DESCRIPTION

[Fig.1]
1 Lock-off button
5 Adjusting bolt (for maxi-
mum cutting capacity)
9 Blade guard
13 Lock lever (for turn base)
17 Pointer (for miter angle)
[Fig.2]
19 Slide pole (upper)
23 Lever (for bevel angle
adjustment)
INSTALLATION

Bench mounting

WARNING:
Ensure that the tool does not
move on the supporting surface. Movement of the
miter saw on the supporting surface while cutting may
result in loss of control and serious personal injury.
1. Fix the base to a level and stable surface, screw-
ing with two bolts. This helps to prevent from tipping and
possible injury.
[Fig.3: 1. Bolt]
2. Turn the adjusting bolt clockwise or counterclock-
wise so that it comes into a contact with the floor sur-
face to keep the tool stable.
[Fig.4: 1. Adjusting bolt]
FUNCTIONAL
DESCRIPTION
WARNING:
Always be sure that the tool is
switched off and the battery cartridge is removed
before adjusting or checking the functions on
the tool. Failure to switch off and remove the battery
cartridge may result in serious personal injury from
accidental start-up.
2 Switch trigger
6 Stopper arm
10 Vertical vice
14 Grip (for turn base)
18 Turn base
20 Thumb screw (for lock-
ing upper slide pole)
24 Slide pole (lower)
3 Blade case
7 Dust bag
11 Guide fence
15 Adjusting bolt (for turn
base)
- -
21 Hex wrench
25 Thumb screw (for lock-
ing lower slide pole)
Installing or removing battery
cartridge
CAUTION:
Always switch off the tool before
installing or removing of the battery cartridge.
CAUTION:
Hold the tool and the battery car-
tridge firmly when installing or removing battery
cartridge. Failure to hold the tool and the battery
cartridge firmly may cause them to slip off your hands
and result in damage to the tool and battery cartridge
and a personal injury.
[Fig.5: 1. Red indicator
cartridge]
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Insert it all the way until it locks in place
with a little click. If you can see the red indicator on the
upper side of the button, it is not locked completely.
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not,
it may accidentally fall out of the tool, causing injury to
you or someone around you.
CAUTION:
Do not install the battery cartridge
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: The tool does not work with only one battery
cartridge.
Tool / battery protection system
The tool is equipped with a tool/battery protection
system. This system automatically cuts off power to
the motor to extend tool and battery life. The tool will
automatically stop during operation if the tool or battery
is placed under one of the following conditions. In some
conditions, the indicators light up.
4 Adjusting screw (for
lower limit position)
8 Bevel scale
12 Holder
16 Kerf board
- -
22 Clamp screw (for locking
holder)
- -
2. Button 3. Battery
ENGLISH 13