Intended Use - Makita DLS714 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Blade diameter
Blade body thickness
Hole (arbor) diameter (country specific)
Max. miter angle
Max. bevel angle
No load speed
Dimensions (L x W x H)
Rated voltage
Battery cartridge
Net weight
Cutting capacities (H x W) with blade 190 mm in diameter
Miter angle
0°
45° (left and right)
57° (right)
1. Max. Cutting capacity when using a wood facing 20 mm thickness
2. Max. Cutting capacity when using a wood facing 15 mm thickness
3. Max. Cutting capacity when using a wood facing 10 mm thickness
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equip-
ment. Be sure that you understand their meaning before
use.
Read instruction manual.
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the blade has come to a com-
plete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
blade.
Always set SUB-FENCE to left position
when performing left bevel cuts. Failure to
do so may cause serious injury to operator.
10 ENGLISH
45° (left)
40 mm x 300 mm
45 mm x 265 mm (NOTE 1)
40 mm x 212 mm
45 mm x 185 mm (NOTE 2)
–
–
DLS714
190 mm
1.3 mm - 2.0 mm
20 mm or 15.88 mm
Left 47°, Right 57°
Left 45°, Right 5°
5,700 min
655 mm x 430 mm x 445 mm
D.C.36 V
BL1815N, BL1820, BL1820B
13.0 kg
Bevel angle
0°
52 mm x 300 mm
60 mm x 265 mm (NOTE 1)
52 mm x 212 mm
60 mm x 185 mm (NOTE 2)
52 mm x 163 mm
60 mm x 145 mm (NOTE 3)
Only for EU countries
Cd
Ni-MH Do not dispose of electric equipment or
Li-ion
battery pack together with household waste
material!
In observance of the European Directives,
on Waste Electric and Electronic
Equipment and Batteries and Accumulators
and Waste Batteries and Accumulators
and their implementation in accordance
with national laws, electric equipment and
batteries and battery pack(s) that have
reached the end of their life must be col-
lected separately and returned to an envi-
ronmentally compatible recycling facility.

Intended use

The tool is intended for accurate straight and miter
cutting in wood.
Noise
The typical A-weighted noise level determined accord-
ing to EN61029:
Sound pressure level (L
Sound power level (L ) : 97 dB (A)
WA
-1
BL1830, BL1840, BL1840B,
BL1850, BL1850B
13.5 kg
5° (right)
40 mm x 300 mm
–
–
–
–
–
) : 88 dB(A)
pA