Indicator Display On The Main Unit; Warning Display - JVC DLA-RS640 Guia De Inicio Rapido

Indicator Display on the Main Unit

Meaning of the lighting figures
The indicator lights up.
The indicator appears blinking.
.
Operation mode display
Displays using the different colors and solid/blinking light of the "STANDBY/ON" indicator.
"STANDBY/ON" lights up (red)
In standby state
STANDBY/ON TANDBY ND LAMP
"STANDBY/ON" blinking (red)
In the Cool-down mode
LAMP
STANDBY/ON TANDBY
.
Estimated timing for lamp replacement
Displays using the solid/blinking light of the "LAMP" indicator. The
"STANDBY/ON" indicator, which shows the operating mode of the
unit, is displayed simultaneously as described above.

Warning display

You can tell the details of a warning from the (repeated) displays of the "WARNING" and "LAMP" indicators. The "STANDBY/ON"
indicator, which shows the operating mode of the unit, is displayed simultaneously as described above.
The Warning mode is activated once the message is displayed. Projection is interrupted, and the cooling fan is turned on for about
100 seconds.
The power cannot be turned on again while cooling is in progress. Check the following after cooling is complete.
Indicator Status (Solid/Blinking)
STANDBY/ON LAMP WARNING WARNING
Mode (*) (Red)
Display
.
STANDBY/ON LAMP LAMP WARNING WARNING
Mode (Orange) (Red)
Display
Blinking
Simultaneously
.
STANDBY/ON LAMP LAMP WARNING WARNING
Mode (Orange) (Red)
.
Display
If the Warning mode is activated again, wait for the cooling fan to stop, followed by pulling out the power plug from the outlet.
Request for repair at your authorized dealer or a nearby service center.
(*) If the scheduled time for lamp replacement is exceeded, the indicator may light up.
10
"STANDBY/ON" lights up (green)
During lamp startup
WARNING STANDBY/ON TANDBY ND
"STANDBY/ON" blinking (green)
When the video image is temporarily hidden (HIDE is on)
WARNING
STANDBY/ON TANDBY
Blinking
Frequency
x1 Abnormality in the power supply
x2 Cooling fan stopped abnormally
x3 Internal temperature is abnormally high
x4 External temperature is too high
x5 Abnormal circuit operation
x1 Abnormal circuit operation
x2
x3
x4 Abnormal operation of the lens cover
x1 Lamp does not light up and unit is
unable to project
RN
x2 Lamp goes out during projection
x3 When the lamp cover is removed
STANDBY/ON
LAMP WARNING STANDBY/ON
LAMP WARNING
"LAMP" lights up (orange)
LAMP LAMP AM
STANDBY/ON
Description
LAMP WARNING
All lights off
During projection
LAMP WARNING
WARNING When lamp replacement is
near
Check and Countermeasure
Check that nothing is blocking the
0
air inlets.
Check that the external temperature
0
is normal.
Countermeasure: Leave the unit
unoperated until it cools down. After
that, turn on the power again.
Check that nothing is blocking the
0
lens cover.
Countermeasure: Turn on the power
again.
Check that the lamp unit and lamp
0
cover are correctly installed.
Countermeasure: Turn on the power
again.