WAGNER FURNO 700 Manual Del Propietário página 12

Storage
Allow the heat gun nozzle to cool to room temperature before placing in
storage.
The nozzle will turn dark over time because of the high heat. This is
normal and will not affect the performance or life of the unit.
accessories
The following accessories may come with the heat gun or may be
purchased separately by calling 1-800-727-4023.
Concentrator Directs a concentrated
heat flow to the
P/N 2366222
work surface. Ideal
for removing paint
in awkward corners,
crevices, mouldings,
beading or architraves.
Flare Directs a long, narrow
heat pattern to the
P/N 2366223
work surface. Ideal
for removing paint
or varnish from large,
flat surfaces such as
skirting boards, doors,
stairs, etc. It should be
used in conjunction
with a flat scraper.
3 2
5-in-1 tool
P/N 2366227
12
EN
Glass Protector Deflects the heat
away from glass or
P/N 2366224
other fragile areas.
Ideal for window
sills, ledges, frames
and skirting
boards.
Curved Deflector Disperses the heat
flow evenly around
P/N 2366225
the whole work
surface. Ideal for
thawing frozen
pipes, solder pipe
work, bending
plastics or heat
shrinking electrical
insulating tubing.
1 The blade (1) is used to scrape paint
and spread compound. The gouge
point (2) is used to remove putty/caulk
and the curved area (3) is used to clean
roller covers. Flat side (4) can also be
used to open paint cans.
4
Case
P/N 2366226
IMPOrTaNT: always use gloves when handling the heat gun.
To attach a nozzle to the gun:
1. Set the heat gun upright on a level surface until the tip is cool.
2. Set the item onto the tip of the heat gun and push firmly into place
by hand.
To remove a nozzle:
1. Set the heat gun upright on a level surface until the tip is cool.
2. Pull the item off of the tip.
The heat gun case has been specifically
designed to locate the heat gun in the
upright position for work on uneven
surfaces.