Stanley SHP 1900 Manual Del Propietário página 14

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
CARE AND MAINTENANCE
Storage
• When your pressure washing session has been
completed, turn off the power switch located on
the front of the power washer. Unplug the power
cord from the outlet. Turn off the water supply. Pull
the trigger on the spray gun 2-3 times to drain out
the excess water and to release any remaining water
pressure. Disconnect the garden hose adapter from
the water inlet.
DO NOT
run with no water flowing through it.
• Remove detergent bottle and clean completely.
Residual chemical will stick to the container and can
cause the detergent injector to clog and not function
properly.
14
93904_16ANR029_Stanley 1900PSI ENG-FR-SP.indd 14
allow the power washer to
• Remove high pressure hose from spray gun.
• Remove lance from the gun. Place the gun in the
holder on the side. Lances are placed into any of the
slots in the back of the unit. Make sure to discard any
remaining detergent from the bottle. Flush the bottle
and nozzle head with fresh water to prevent clogging.
• Hook the power cord around the L-shaped tabs on the
right side of the machine when facing it.
16/12/14 下午5:47