Stanley SHP 1900 Manual Del Propietário página 7

ASSEMBLY INSTRUCTIONS
3
4
I
B
1
Pull back on collar at the other end of the high pressure
hose (B). Push firmly to connect hose to spray gun (I).
Twist collar to secure. Confirm hose is locked into spray
gun by slightly pulling on them. The hose is now
securely attached to spray gun.
93904_16ANR029_Stanley 1900PSI ENG-FR-SP.indd 7
A
B
2
3
B
Soft PVC High Pressure Hose Assembly
Screw Soft PVC high pressure hose (B) clockwise onto
bottom left, when facing the unit, front of power
washer unit (A). Pull back collar and insert o-ring post
into water outlet far enough so collar can thread onto
outlet threads until hand tight. If it takes fewer than
six turns you have not properly tightened the Soft
PVC high pressure hose fitting. It is easier to position
the power washer in front of you to ensure that the
threads are started correctly. Failure to properly tighten
Soft PVC high pressure hose will result in the hose
slipping or popping off immediately upon turning unit
on. Do not worry about damage if this occurs–just
reinstall and take extra care when screwing on the Soft
PVC high pressure hose fitting.
use pliers or locking pliers to tighten.
Note: DO NOT
5
I
3
B
2
B
Twist collar then pull back to release the the high
pressure hose (B) connection from the gun (I)
1
3
7
16/12/14 下午5:47