Installing The Shoulder Strap; Adjusting The Shoulder Strap - Makita DVC340 Manual De Instrucciones

011114
At this time, make sure that the fastener part on the dust
bag faces upward.
NOTE:
When the dust bag joint and the ring inside the
•
dust bag come off, install as follows.
(1) Align the dust bag joint with the seam of the
dust bag and install it so that its protrusion
faces upward.
011115
(2) Tighten the ring inside the dust bag firmly so
that the pins and the ring are positioned as
shown in the figure.
1
011116
1. Hook
1
1. Protrusion
1
1. Pins
2
2. Ring

Installing the shoulder strap

1
011117
Attach one end hook of the shoulder strap onto the ring
in the front of the cleaner and thrust the other end of the
strap through the band of the dust bag and then attach
the other end hook as shown in the figure.

Adjusting the shoulder strap

1
3
011118
To adjust the length of the shoulder strap, pull it out to
your desired length and pull the strap in the direction of
arrow as shown in the figure.
Connecting the hose
CAUTION:
Do not force the hose to bend it and/or stamp it.
•
Forcing and/or stamping the hose may cause
deformation or damage to the hose.
Do not pull the hose to carry the cleaner. Pulling
•
the hose may cause deformation or damage to the
hose.
6
1. Shoulder strap
2. Two hooks
2
1. Pull out
2. For shortening
3. For extending
2