ROBBE Charterte Instrucciones De Montaje página 6

Parts List for the basic tailplane structure
Part Description
No.
Tailplane and elevator
L 1 Tailplane centre section
L  Tailplane leading edge
L 3 Tailplane tip
L 4 Tailplane trailing edge
L 5 - L 10 Tailplane cross-piece
L 11 Elevator panel
L 1 Elevator centre cross-piece
L 13 - L 15 Elevator cross-piece
L 16 Elevator leading edge
L 17 Elevator horn
Fin and rudder
S 1 Fin strake
S  Fin
S 3 Rudder
S 4 Elevator horn
Building the tailplane and fin
Fig. 25
- Pin down the tailplane centre section L 1 over the plan,
and glue the leading edge strips L , the tips L 3 and the
trailing edge L 4 to it.
Fig. 6
- Trim the cross-pieces L 5 - L 10 to fit neatly, and glue
them between the leading and trailing edges as shown.
- Remove the structure from the building board when the
glue has set hard.
- Round off the leading edges and tips to a symmetrical
profile, as shown in the detail photo.
Assembly and operating instructions
Charterle
Laser-cut
sheet
Sheet E
Sheet E
Sheet E
Sheet E
Sheet E
Sheet D
Sheet D
Sheet D
Sheet B
Sheet F
Sheet G
Sheet G
Sheet G
Sheet F
Fig. 27
- Pin down the elevator panel L 11 over the plan.
- Glue the elevator leading edge strip L 16 in place, flush
with the leading edge of the elevator sheet.
Fig. 28
- Glue the cross-pieces L 1 - L 15 to the elevator.
- Allow the glue to set hard, then remove the elevator from
the building board, sand it to the profile shown in the
cross-section on the plan, and bevel the front face of part
L 16.
Fig. 29
- Glue the fin strake S 1 to the fin S .
Material, dimensions No. off
Balsa, 4 mm 1 off
Balsa, 4 mm  off
Balsa, 4 mm  off
Balsa, 4 mm 1 off
Balsa, 4 mm  each
Balsa,  mm 1 off
Balsa,  mm 1 off
Balsa,  mm  each
Balsa,  mm 1 off
Plywood,  mm 1 off
Balsa, 3 mm 1 off
Balsa, 3 mm 1 off
Balsa, 3 mm 1 off
Plywood,  mm 1 off
6
Fig. 30
- Sand the completed fin S 1 / S  and the rudder S 3
smooth. Bevel the leading edge of the rudder S 3 as
shown on the plan - see the arrow in the photo.
- The control surfaces and the horns L 17 and S 4 should
not be attached to the tail surfaces until the model has
been covered.
No.
3279