dirna Bergstrom bycool COMPACT 1.4 Instrucciones De Montaje página 17

COMPACT 1.4
3
CABIN EXTERIOR:
Position the Compact in the hatch gap.
Caution! When positioning the unit above the
hatch gap, check that the wastewater run-offs
are not blocked by the EPDM seal.
4 Position the foam rubber, ensuring the softest part
is placed on the base of the unit.
Caution: Depending on the cabin, it may be
necessary to use the (2) supplied ducts in order for
the distribution panel to be completely adjusted.
5 Position (4) Ø6 rubber washers, (4) Ø6 wide-
rimmed flat washers on L=43 hexagons. Then
tighten the hexagons until the rubber washer is
slightly oppressed.
5
L=43
4
5
Widerimmed flat washers
5
Rubber washers
17
®
Hatch
L= 43
EN
3