Sw Out Terminal - Sony SVT-N72P Manual De Instrucciones

1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "4" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The ALARM SET menu appears.
4
Press MENU V to move the flashing to the setting
of TAPE END WARN. and set to COUNT. or
END by pressing MENU + or –.
COUNT.: the time counter shows "3:00:00" and
then signal is output from the TAPE END/
SERIES OUT terminal (recording will be
continued to the end of the tape).
END: the VCR detects the tape end.
5
Press SEARCH/AUDIO ON to return to the
normal display.
SERIES OUT Terminal
You can make series recording by connecting another
SVT-N72P.
For the details on connection, see page 10 and on
operation, see page 21.

SW OUT Terminal

The VCR outputs a pulse signal from the SW (switch)
OUT terminal to the camera switcher to control the
switching from camera to camera.
COM terminal
Specify the interval between each pulse signal on the
SW OUT SET menu. Also, set MODE to FIELD or
FRAME depending on the specifications of the camera
switcher.
Available settings are:
• FIELD: 1, 2, 3, 4, 5, 10, 30, or 60 fields
• FRAME: 1, 2, 3, 4, 5, 10, 30, or 60 frames
1
Turn on the power of the equipment to be used.
2
Press MENU and MENU V until "3" of the MAIN
MENU flashes on the monitor screen.
3
Press MENU B.
The SW OUT SET menu appears.
SW OUT terminal
45