dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 21

COMPACT
In general, the roof of the cabins are strong
!
enough to support the weight of the unit; if
this is not the case, reinforce the cabin roof to
ensure it withstands the weight of the unit and
prevent any deformation.
In vehicles which do not have a hatch but
!
have the contour for installation marked in the
roof, make the cut in the pre-marked contour,
leaving the distance necessary to position the
seal. This operation is always carried out
with the authorisation of the customer.
In vehicles which do not have a hatch and do not
!
have the contour for installation marked in the
roof, it is necessary to cut at the measurements
indicated in the place chosen to position the
equipment. This operation is always carried
out with the authorisation of the customer.
If cuts or boreholes are made in the vehicle's
!
bodywork, we recommend applying anti-rust
paint to prevent any corrosion.
Direction of travel
=
21
®
460 mm
=
(4) Ø 9
485 mm
EN ES