dirna Bergstrom bycool COMPACT 3.0 Instrucciones De Montaje página 26

COMPACT
ES
EN
VEHICLES WITH ORIGINAL HATCH AND WITHOUT PRE-MARKING IN THE ROOF
Position (1) Ø7 rubber washer, (2) Ø8 flat
5
wide-rimmed washers and (2) M8 nuts and (4)
Ø8 shorter studs in the indicated position.
Screw the studs 15 mm in the M8 inserts of
6
the base and tighten the nuts against it.
Caution: The rubber washer remains in place
against the base of the unit.
Position the Compact on the cut made.
7
Introduce the studs in the Ø9 (*) boreholes
made along with the cut.
Caution: Check that the water run-offs are
outside the EPDM seal and are not obstructed
by it.
FOR INSTALLATION OF THE HATCH
Ø8 Flat wide-
Rubber
rimmed washer
washer
5
26
®
Ø8 Flat wide-
M8 Nut rimmed washer