Transport And Storage; Transportation And Storage; Limitations - Pentair STA-RITE Serie Manual De Instrucciones

EN
CHAPTER 2

TRANSPORT AND STORAGE

•
Each machine is carefully tested and
packed during the assembly phase
•
On receiving the pump, customers
will have to verify: that the product
complies with the data quoted in
the order; that is has not suffered
damages during transportation.
All damages should be immediately
reported to the distributor within 8
(eight) days from the date of purchase
•
Don't disperse and/or throw the
packaging away and take all possible
measures to re-use it and recycle it
CHAPTER 3

LIMITATIONS

SCM 4 Plus®, SCM 4 HF and SA 6 pumps are designed to pump clean water (for the food industry).
The operation of this water pump with variable duty points may be more efficient and economic when controlled, for example, by the
use of a variable speed drive that matches the pump duty to the system.
Information on benchmark efficiency is available at www.europump.org/efficiencycharts
WARNING
Electric pump cannot be used to move inflammable or dangerous liquids.
WARNING
Ensure electric pump never runs dry.
•
Max. temperature of pumped liquid: 30
°C (SCM 4 ),
®
25 °C (SA 6)
•
Max. free passage: 3 mm
10
•
Before transporting the unit, check
the following data: weight of the pump
(or the pump end), overall dimensions,
lifting points
•
The pump (or the pump end) has to be
transported with equipment suitable to
its weight and dimensions. Only pumps
(or units) with a weight below 20 Kg
can be transported manually
•
Maximum sand quantity: 50 g/m
4 ), 40 g/m (SA 6)
® 3
•
Max. on/off cycles/hour:
20 (SCM 4 ),
®
15 (SA 6) equally distributed
•
The units have to be stored in closed,
dry and ventilated areas avoiding
excessively low temperatures. If
the units have to be stored for long
periods of time (above 12 months) or
in presence of low temperatures, it is
necessary to rotate the shafts and the
hydraulic unit at least once a month
•
Protect the terminals of the cables
from humidity, making sure that
these are not bent with curves above
6 times their diameter. If the single
components are stored individually,
protect the rubber parts and the thrust
bearings from direct sun light
•
(SCM Min. well diameter:
3
100 mm (SCM 4
150 mm (SA 6)
•
Max. immersion depth: 150 m
)
®