Rearward-Facing Installation - Joie tilt Manual De Instrucciones

Rearward-Facing Installation

see images -
13 18
13
14
1
1. Pull out the vehicle belt and engage the vehicle buckle
tongue into the buckle.
13
- 1 Vehicle shoulder belt
13
- 2 Vehicle Waist belt
13
2. Rotate the child restraint rearward and thread the vehicle
waist belt through the two rear-facing vehicle waist belt slots
underneath the shell.
14
- 1 & - 2 Vehicle belt slot
14 14
The correctly assembled belt is shown in
13
1
2
2
.
15
15
3. Install the vehicle shoulder belt
in the two rear-facing vehicle
shoulder belt slots at the back
of the seat shell.
16
!
Shoulder belt must pass
through the rear-facing
shoulder belt slots.
4. While pressing the child
restraint firmly into the vehicle
seat, pull the vehicle shoulder
belt to fasten the child restraint
tightly and securely.
17
!
Please check if the child
restraint is installed tightly by
moving the child restraint
back and forth at the vehicle
belt path (child restraint
should not move more than
25mm/1").
!
The child restraint cannot be
used if the vehicle safety belt
buckle (female buckle end) is
too long to anchor the child
restraint securely. - 3
17
16
17
3
14