Installation For Rearward Facing Mode; Securing Your Child In The Child Restraint - Joie every stage R129 Manual De Instrucciones

i. Installation for Rearward Facing Mode
!
Please adjust the enhanced child restraint to the desired recline position (2
positions for rearward facing mode). Align the top reclining indicator with
one of the bottom white numbers.
!
Make sure the shoulder harness is adjusted to proper height before
installing this enhanced child restraint.
!
When installing and adjusting the safety belts, make sure that both the
shoulder belt and the lap belt are not twisted and will not stop the safety
belts from functioning properly.
1. Pass the vehicle lap belt through the vehicle lap belt slots, then engage the
vehicle buckle tongue into the buckle.
!
Vehicle lap belt must pass underneath infant insert.
2. Pass the vehicle shoulder belt through the two rear-facing vehicle belt slots
at the back of the enhanced child restraint.
!
Open the belt lock off and insert the shoulder belt through it.
!
Ensure the belt lock off is completely closed when not in use to prevent
injury, or damage to vehicle upholstery.
3. Press the enhanced child restraint down firmly and pull the vehicle
shoulder belt to fasten the enhanced child restraint securely.
!
Ensure to close the lock-off after checking the enhanced child restraint is
securely fastened. -3& -4
12 12
!
Keep your fingers off when closing the lock-off clips to avoid injury.
!
The enhanced child restraint can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the enhanced child
restraint securely.
!
Double check that the enhanced child restraint is securely installed and
does not move on the vehicle seat.
4. Correctly assembled vehicle belt is shown as
!
Ensure that the vehicle lap belt passes through the vehicle lap belt slot.
-1
13
!
Ensure that the vehicle shoulder belt passes through the rear-facing vehicle
belt slot. -2
13
!
The vehicle buckle tongue is engaged with the buckle correctly, as
16
8 9
10
11
12 -1& 12 -2
13
-3
13
ii. Securing your Child in the Child Restraint
Use Infant Insert
Detach the snaps on
the head support to
remove the head
portion of the insert.
We recommend using the
full infant insert while the
baby is under 60cm and
can be used until they
outgrow the infant insert.
The infant insert increases
side impact protection.
1. While pressing the harness adjustment button, pull completely the two
shoulder harnesses of the enhanced child restraint.
2. Press the button to disengage the buckle.
3. Fix the buckles on the both sides of seat to make placing the baby more
convenient.
16
Place the child into the enhanced child restraint and pass both arms
through the harnesses.
4. Engage the buckle.
5. Pull the adjustment webbing toward you to adjust it to the proper length
and make sure your child is snugly secured.
!
After the child is seated, recheck whether the shoulder harnesses are at
the proper height.
!
Always keep child secured in harness and properly tightened by removing
any slack.
Remove the head support
portion of the infant
insert when the child's
head no longer fits
comfortably.
Remove the body
portion of the infant
insert when the infant's
shoulders no longer fit
comfortably.
Remove the infant insert
1
cushion by detaching the
snaps to allow more space
when the infant does not
fit comfortably. The
cushion can be used
2
separately without being
attached to the insert to
bolster the infant's back
for more comfort.
14
15
18
17