Securing Your Child In The Child Restraint - Joie tilt Manual De Instrucciones

38
The assembled vehicle safety belt is shown in
!
Ensure vehicle shoulder belt passes through Lock-off Device,
as shown in - 1.
38
!
Ensure vehicle waist belt passes through the forward-facing
vehicle waist belt slots, as shown in
!
Ensure that the vehicle buckle tongue is engaged with the
buckle correctly, as shown in

Securing your Child in the Child restraint

see images
39
39
25
1
2
3
.
38
- 2.
38
- 3.
38
1
Note
1. When installing the child restraint in the forward-facing mode,
DO NOT use the infant body support.
2. Please install the child restraint on the vehicle seat first, and
then place the child in the child restraint.
3. After the child is placed into the child restraint, check whether
the shoulder harness straps are at the proper height. Please
refer to Proper Position of the Shoulder Harness Straps
Shoulder Harness Straps Height
1. Pull up the webbing adjuster, while pulling the shoulder
harness straps to the proper length.
- 1 Webbing adjuster
8
2. Press the red button to disengage the buckle
leave the harness straps on the left and right sides of the child
restraint.
9
3. Place the child in the child restraint and pass both arms under
the shoulder harness straps.
!
After the child is seated, recheck whether the shoulder
harness straps are at the proper height. Please refer to
Proper Position of the Shoulder Harness Straps
Harness Straps Height Adjustment.
4. Pull down the adjustment webbing and adjust the harness so
that your child is snugly secured.
!
Make sure the space between the child and the shoulder
harness straps is about the thickness of one hand.
&
Adjustment.
8
- 1, and then
9
39
& Shoulder
22
- 1
39
26