BH FITNESS tourmalet H910EFB Instrucciones De Montaje página 11

using a 3mm Allen key to adjust the
set screw.
-Apply a little oil to the contact point of
the pedal clip with the pedal to ensure
that it locks on.
-Oil to the pedal springs regularly.
(Pedal instructions attached)
2. CHECKING THE TIGHTENING
KNOBS.-
The 3 tightening knobs should be
loosened off and sprayed with a
lubricant to ensure that they remain
operative.
MAINTENANCE EVERY 200
HOURS.-
1. CHECKING & ADJUSTING THE
BELT
-Check that the belt is tensioned
properly. If the belt skids it will be
necessary to tighten the belt.
-Remove the side covers (6) and
loosen the nuts a maximum of two
turns Fig.7.
-Tighten the small
spanner. Make sure that the nut
rotates the same number of turns on
both sides of the machine (generally 2
turns will be sufficient) otherwise the
drive sprocket might become skewed,
creating a lot more noise and making
it possible for the belt to fall off.
-Tighten up nuts again and put the
side covers (6) back in their place.
-Whenever the tension setting on the
machine is adjusted, readjust the
brakes as well.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE.
Do not hesitate to get touch with us if
you have any queries, by calling:
nuts with a
11
+44 0844 335 3988
service@bh-uk.co.uk