BH FITNESS tourmalet H910EFB Instrucciones De Montaje página 9

1.- ASSEMBLY INSTRUCTIONS.-
The assistance of a second person
is recommended when assembling
this unit.
1. Take the unit out of its box and
make sure that all of the pieces are
there Fig.1: (67) Main body; (49)
console; (21) Handlebar;
Handlebar stem; (41) Saddle post;
(40) Horizontal saddle
Saddle; (12) Rear stabiliser bar with
adjustable feet; (16) Front stabiliser
bar with wheels; (68) Left pedal; (11)
Right pedal; (10) Slot head bolt M-10;
(9) Flat washer M-10; (8) Cap nut M-
10; Double ended spanner.
2. Position the machine's rear stand
on the rear stabiliser bar (12), as
shown in Fig.2, insert the bolts (10), fit
the flat washers (9) and cap nuts (8)
and then tighten securely.
3. Position the front stabiliser bar with
wheels (16), paying attention to the
red dots and with the wheels facing
forwards, as shown in Fig.2, insert the
bolts (10), fit the flat washers (9) and
cap nuts (8) and tighten securely.
2.- FITTING THE PEDALS.-
The assembly instructions for the
pedals must be followed to the letter,
fitting these incorrectly could damage
the screw thread on either the pedal or
the crank.
Right and left refer to the position that
the user adopts when sitting on the
saddle to do the exercises.
The right-hand pedal, marked with the
letter (11), screws onto the right-hand
crank, also marked with an (R), in a
clockwise direction. Tighten securely,
Fig.3.
The left-hand pedal, marked with the
letter (68), screws onto the left-hand
crank, also marked with an (L), in an
anti-clockwise
securely, Fig.3.
3.- ATTACHING THE SADDLE.-
Fit the saddle bracket (1), Fig.4, onto
the horizontal saddle tube (40), as
shown in Fig.4, fit the saddle into
(37)
position and tighten the nuts on the
bracket
tube; (1)
horizontal saddle tube (40) through the
hole on the saddle post (41), Fig.4,
position it correctly and tighten the
knob (S), Fig.4. Insert the saddle post
(41) into the boss on the main body
(67), position it correctly and tighten the
saddle post by using the adjustment
knob (T), Fig.4, turning it clockwise.
ADJUSTING THE SADDLE HEIGHT.-
Loosen the saddle post adjustment
knob
anticlockwise, Fig.4, move the saddle
to a position comfortable for doing
exercise
adjustment knob (T) securely by
turning it clockwise.
HORIZONTAL ADJUSTMENT OF
THE SADDLE.-
Loosen the knob (S) slightly by turning
it anticlockwise, Fig.4, move the
saddle to a position comfortable for
doing exercise and then tighten the
knob
clockwise.
4.- FITTING THE HANDLEBAR.-
Position the handlebar (21) on the
handlebar stem (37), Fig.5, tighten the
knob (V) and then insert the handlebar
stem (37) into the hole on the main
body (67), Fig.5. Position it correctly
and then tighten knob (Y) by turning it
clockwise.
9
direction.
securely. Next insert
(T) slightly by turning
and then tighten
(S) securely by turning
Tighten
the
it
the
it