Preliminary Checks; Deciding From Which Side Of The Wheel The Tyre Must Be Removed - CEMB SM1100 Manual De Uso

To prevent any rim damage, the plastic insert under
the head must be replaced every 2 months or sooner,
if excessively worn. A spare insert is supplied with the
machine.

9.1. PRELIMINARY CHECKS

Check that there is a pressure of at least 8 bar on the filter regulator pressure gauge.
If the pressure is below the minimum level, some machine operations may be limited
or insufficient.
After the correct pressure has been restored, the machine will operate properly.
Check that the machine has been adequately connected to the electric mains and the
pneumatic supply.
9.2. DECIDING FROM WHICH SIDE OF THE WHEEL THE
TYRE MUST BE REMOVED
See Fig.13. Identify the position of channel A on the rims. Identify the greater width B
and the smaller width C. The tyre must be mounted and demounted with the wheel on
the turntable with the smallest width side C facing upwards.
See the paragraph "TABLE FOR USING CENTRING AND CLAMPING ACCESSO-
RIES ACCORDING TO RIM TYPE" in this manual.
When working with "easily deformable" rims (i.e. a
central hole with thin, projecting edges - see Fig. 18A)
we recommend using the universal flange for blind
rims (see the section "TABLE FOR USING CENTRING
AND CLAMPING ACCESSORIES IN RELATION TO
RIM TYPE" in this manual)..
34
WARNING
WARNING
B
A
13
User's manual