Aux-In Operation - Roadstar HRA-1500D+ Manual De Instrucciones

matically. It will display and play the first station after the scan is done);
3. Select the desired audio source by pressing the [MODE] button (4);
4. (Please see detailed instructions for each Source in the following chapters);
5. Adjust the volume with the [VOLUME KNOB] (1) to the desired level;
6. To power OFF the radio, press the [POWER] button (1).
Note: For a better reception reorient the antenna (14).
DAB RADIO OPERATION
1. Use the [TUNING KNOB] (11) to select the desired radio station.
2. Confirm with the [ENTER] button (11).
Note: In case there is No DAB Service, press & hold the [MENU] button (9) and select
"Station Scan" and then "Full Scan" to start scanning.
FM RADIO OPERATION
Use the [TUNING KNOB] (11) to fine tune the frequency in a step of 0.05 MHz or
•
Press [SCAN] button (6) to scan the previous/next available station.
•
PRESET
There are 10 presets available for DAB and 10 presets for FM.
1. Set the desired radio station frequency as explained previously;
2. Press the [PRESET] button (8);
3. Choose the number of preset using the [TUNING KNOB] (11);
4. Press and hold the [ENTER] button (11) until the display shows "Preset Stored".
RECALL A PRESET STATION
1. Press the [PRESET] button (8);
2. Select the desired preset
3. Confirm with the [ENTER] button (11).
INFO
When the radio station is playing, press the [INFO] button (9) repeatedly to cycle through the
information broadcasted by the radio.

AUX-IN OPERATION

1. Use one male to male 3.5mm jack cable (not included) to connect any external audio
device to the [AUX-IN SOCKET]
2. Select "AUX" mode by pressing repeatedly the [MODE] button (4).
Note: Music control (play, pause, etc) must be done from your external device.
NAVIGATE INTO THE MENU
1. Press and hold the [MENU] button (9) to access to the options;
2. Use the [TUNING KNOB] (11) to navigate into the options;
3. Press [ENTER] (11) to select the options;
4. Press [MENU] (9) to exit the menu.
CLOCK AND DATE SETTING
When the radio is ON:
1. Press and hold [MENU] (9) to access to the menu;
2. Use the [TUNING KNOB] (11) to select "System";
3. Confirm with the [ENTER] button (11);
4. Use the [TUNING KNOB] (11) to select "Time Setup";
5. Confirm with the [ENTER] button (11);
using the [TUNING KNOB] (11);
(12);
English 2