Schumacher Electric PI-200 Manual Del Usuario página 6

Connecting inverter cable to a vehicle (100 watts maximum)
[All models]:
1. Remove the cigarette lighter from its outlet.
2. Push the 12-volt power plug firmly into the outlet.
Connecting inverter cables to 12V battery or 12V power source
(Models PI-400, PI-750 and XI41B):
1. Keep hands, hair, clothing and jewelry clear of battery terminals.
2. Wear eye protection and protective clothing.
3. Connect the positive (red) inverter terminal cable to the
power source positive (+) or battery terminal. Make sure the
connection is secure.
4. Connect the negative (black) inverter terminal cable to the
power source negative (-) or battery terminal. Make sure the
connection is secure.
5. To disconnect the inverter, reverse the above steps.
NOTE: The internal speaker may make a brief "beep" when the
inverter is being connected to or disconnected from the 12-volt
power source.
blown fuses and permanent damage to the inverter.
5. OPERATING INSTRUCTIONS
1. Connect the inverter (see "CONNECTING INVERTER
CABLES" section).
2. Make sure the device to be operated is turned OFF.
3. Plug the device into the inverter AC outlet.
4. Switch the inverter's ON/OFF switch to the ON position.
5.
Turn the device on.
6. To disconnect, reverse the above procedure.
NOTE: If more than one device is to be powered, start one device
at a time to avoid a power surge and overloading the inverter.
The surge load of each device should not exceed the inverter's
Continuous Operation wattage rate.
Failure to make the correct connections will result in
• 6 •