Safety Instructions - Eneo VKCD-1326/IR Instrucciones De Manejo

1. Safety Instructions

• Read these safety instructions and the operation manual first before you install
and commission the camera.
• Keep the manual in a safe place for later reference.
• Protect your camera from contamination with water and humidity to prevent it
from permanent damage.
Never switch the camera on when it gets wet. Have it checked at an authorized
service center in this case.
• Never operate the camera outside of the specifications as this may prevent the
camera functioning.
• Do not operate the cameras beyond their specified temperature, humidity or
power ratings.
• Operate the camera only at a temperature range of -0°C to +50°C and at a
humidity of max. 90%.
• To disconnect the power cord of the unit, pull it out by the plug. Never pull the
cord itself.
• Pay attention when laying the connection cable and observe that the cable is not
subject to heavy loads, kinks, or damage and no moisture can get in.
• Do not attempt to disassemble the camera board from the dome.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
Do not open the camera housing.
• Never point the camera towards the sun with the aperture open. This can destroy
the sensor.
• Installation, maintenance and repair have to be carried out only by authorized
service centers.
Before opening the cover disconnect the unit from mains input.
• The fitter is responsible for the system of protection being followed in accordance
with the technical data, e.g. by sealing of the cable outlet with silicone.
• All openings provided in the housing for assembly purposes must be closed
and/or sealed.
• Contact your local dealer in case of malfunction.
• Only use original parts and original accessories from Videor E. Hartig GmbH.
5