Safety Instructions; General Description; Supplied Items - Eneo VK-1315S Instrucciones De Manejo

1. Safety Instructions

• Read these safety instructions and the operation manual first before you install and commission the camera.
• Keep the manual in a safe place for later reference.
• Contact your local dealer in case of malfunction.
• Protect your camera from contamination with water and humidity to prevent it from permanent damage.
Never switch the camera on when it gets wet. Have it checked at an authorized service center in this case.
• Do not open the camera housing. Maintenance and repair have to be carried out only by authorized service
centers.
• Operate the camera only at a temperature range of –10°C to +50°C and at a humidity of max. 90%.
• To disconnect the power cord of the 230 VAC cameras, pull it out by the plug. Never pull the cord itself.
• The camera is equipped with an automatic gain control (AGC) which increases the sensitivity at low light levels.
Noisy pictures at these conditions are quite normal.
• Pictures including bright spotlights will cause perhaps vertical lines (smear) or soft edges (blooming) on the
monitor display. This happens most probably in automatic shutter mode (AES). This is not a defect but an effect
caused by the CCD sensor.
• If you are using an AI or DC controlled lens, switch OFF the automatic electronic shutter control (E/I-OFF).
If it is ON, flickering may occur. If a manual lens is used, switch ON the E/I.
The cameras should never:
• be operated beyond the technical specifications. This can lead to destruction.
• pointed with open iris towards the sun. (This can damage the sensor).
• Use only a mild detergent to clean the housing. Never use dilution or gasoline for this can cause permanent
damage to the surface.

2. General Description

• 1/3" Interline Transfer CCD, VK-1315S standard resolution (380 TV lines)
• 1/3" Interline Transfer CCD, VK-1316S high resolution (570 TV lines)
• Backlight compensation (BLC)
• Automatic Gain Control (AGC)
• Automatic shutter control (AES)
• 230VAC, 24VAC and 12VDC power supply
• C/CS Mount lenses

Supplied Items

• Camera VK-1315S or VK- 1316S with CS lens mount
• 4 pin plug for video or DC controlled lenses
• C/CS mount ring
• Dust cover
• Operating instructions
13