Preparing Tungsten Electrode For Welding; Section 6 − Guidelines For Tig Welding (Gtaw); Positioning The Torch - Miller Diamondback Serie Manual Del Operador

Ocultar thumbs Ver también para Diamondback Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

5-2. Preparing Tungsten Electrode For Welding

Y Grinding the tungsten electrode produces dust and flying sparks which can cause injury and start fires. Use
local exhaust (forced ventilation) at the grinder or wear an approved respirator. Read MSDS for safety infor-
mation. Consider using tungsten containing ceria, lanthana, or yttria instead of thoria. Grinding dust from
thoriated electrodes contains low-level radioactive material. Properly dispose of grinder dust in an environ-
mentally safe way. Wear proper face, hand, and body protection. Keep flammables away.
A. Preparing Tungsten For DC Electrode Negative (DCEN) Welding Or AC Welding With Inverter Machines
Radial Grinding
Causes Wandering Arc
Wrong Tungsten Preparation
B. Preparing Tungsten For Conventional AC Welding
SECTION 6 − GUIDELINES FOR TIG WELDING (GTAW)

6-1. Positioning The Torch

2
1
90
°
10−15
4
°
10−25
Bottom View Of Gas Cup
OM-1600 Page 10
2
Ideal Tungsten Preparation − Stable Arc
1
2
3
4
°
5
6
5
6
1/16 in
3/16 in
Return To Table Of Contents
2-1/2 Times
Electrode Diameter
3
1
4
1 − 1-1/2 Times
Electrode Diameter
Y Weld current can damage electronic parts in vehicles. Discon-
nect both battery cables before welding on a vehicle. Place work
clamp as close to the weld as possible.
.
For additional information, see your distributor for a handbook on the
Gas Tungsten Arc Welding (GTAW) process.
1
Workpiece
Make sure workpiece is clean before welding.
2
Work Clamp
Place as close to the weld as possible.
3
Torch
4
Filler Rod (If Applicable)
5
Gas Cup
6
Tungsten Electrode
Select and prepare tungsten according to Sections 5-1 and 5-2.
Guidelines:
The inside diameter of the gas cup should be at least three times the
tungsten diameter to provide adequate shielding gas coverage. (For
example, if tungsten is 1/16 in diameter, gas cup should be a minimum of
3/16 in diameter.
Tungsten extension is the distance the tungsten extends out gas cup of
torch.
The tungsten extension should be no greater than the inside diameter of
the gas cup.
Arc length is the distance from the tungsten to the workpiece.
1
Grinding Wheel
Grind end of tungsten on fine grit, hard
abrasive wheel before welding. Do not use
wheel for other jobs or tungsten can become
contaminated causing lower weld quality.
2
Tungsten Electrode
3
Flat
Diameter of this flat determines amperage
capacity.
4
Straight Ground
Grind lengthwise, not radial.
1
Tungsten Electrode
2
Balled End
Ball end of tungsten by applying AC amper-
age recommended for a given electrode
diameter (see Section 5-1). Let ball on end of
the tungsten take its own shape.
Ref. ST-161 892

Publicidad

Tabla de contenido
loading

Tabla de contenido