Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Classic
®
30 Control Panel
11
13
12
10
POWER SWITCH
1
Switch to "ON" position to activate.
STANDBY SWITCH
2
Allows amp to be placed in standby or active mode. In standby mode the tubes remain hot, but the
amplifier is not operational.
PILOT LIGHT LED
3
Illuminates when AC power is being supplied to the unit.
EFFECTS SEND
4
Output for supplying signal to external effects or signal processing equipment.
EFFECTS RETURN
5
Input for returning signals from external effects or signal processing equipment.
TREBLE, MIDDLE, AND BASS EQ
6
Passive tone controls that regulate high, mid, and low frequencies, respectively.
BOOST SWITCH
7
Boosts the overall system gain. Depress to the "in" position to activate.
REVERB
8
Reverberation is an echo effect. Rotate clockwise to increase the effect. Remote footswitch can control
ON/OFF.
POST GAIN
9
Controls the overall volume level of the Lead channel. The final level adjustment should be made after
the desired sound has been achieved.
PRE GAIN
10
Controls the input volume level of the Lead channel.
CHANNEL SELECT SWITCH
11
Allows selection of the Lead or Normal channel.
NOTE: Channel selection may also be achieved by the remote footswitch. If remote selection is
desired, the channel switch must be in the "in" (Lead) position.
NORMAL GAIN
12
Controls the volume level of the Normal channel.
INPUT
13
The input jack will accept signals from all types of guitar pickups. Be sure to use a high-quality
shielded cable to connect the guitar to the amplifier.
9
8
7
5
4
6
3
2
1
Publicidad
Tabla de contenido
