Description Of Mixer (See Fig.1) - WAGNER PlastMix 15 Manual De Instrucciones

GB

2
3
4
2.3

DESCRIPTION OF MIXER (SEE FIG.1)

The mixer comprises a wheeled frame (ref.1), which supports a
hopper (ref.2), a mixing chamber (ref.3), a water circuit (ref.9),
an electrical panel (ref.5).
The pre-mixed dry material is poured in to the hopper (using
sacks or by means of other equipment), which houses an au-
ger batching system (ref.6), activated by a gearmotor (ref.7),
which moves the auger, transferring the material into the
mixing chamber. This chamber is fitted with a mixer (ref.8),
which connected to the auger, mixes the material with water
delivered directly to the chamber by the water pump and via
the water circuit.
The mixed material is then conveyed to the discharge outlet
(ref.4).
18
10
5
1
7
9
6
11
(1) WHEELED FRAME
(2) HOPPER (DRY ZONE)
(3) MIXING CHAMBER (WET ZONE)
(4) MATERIAL OFFLOAD PORT
(5) ELECTRICAL PANEL (WITH ON/OFF SWITCH)
(6) AUGER TYPE BATCHING SYSTEM
(7) GEARMOTOR
(8) MIXER
(9) WATER CIRCUIT
(10) HOPPER GRID
(11) WATER PUMP (ACCESSORY)
PlastMix 15
8