Using The Rip Fence Pointer When Table Is Not Extended - Bosch GTS1041A Instrucciones De Funcionamiento

PRE-CUT LOCATOR
Allows you to mark and locate exactly where the
blade will enter the work piece.
Always make sure table saw is turned off and un-
plugged.
Set blade 1 at 90 degrees square to table. Using
a straight edge and a soft pencil, place straight
edge 2 against both sides of blade and mark lines
on locator 3 (Fig. 43). These lines indicate the
"path" of the cut (kerf) made by the blade. When
cutting the work piece, line up mark on work
piece with the line on the disc (Fig. 44).
USING THE RIP FENCE POINTER
WHEN TABLE IS NOT EXTENDED
The rip fence pointer shows the distance from the
blade to rip fence through a convenient viewing
and magnifying window. Align rip fence pointer 4
with lower portion of scale 5. The lower scale can
be used for widths up to 12.75 inches (Fig. 45).
USING THE TABLE POINTER WHEN
TABLE IS EXTENDED
The upper portion of scale 6 is used for rip cut
12.75 to 25 inches. Align table pointer 7 with up-
per portion of scale 6 (Fig. 45).
MAKING RIP CUTS BEYOND 25 INCH-
ES WITHOUT THE USE OF SCALE
When positioning fence for maximum rip without
the use of scale, loosen screw 8 and lower plate
9 below the head 10 of the rip fence 11 (Fig. 45).
DO NOT rip or cut dados with the fence beyond
this position because it cannot be locked.
Fig. 45
6
5
1600A009XC 09-15.indb 29
15 14 13
8 9 10 11
Fig. 43
1
3
Fig. 44
7
Changing to
Table Pointer
12 13
4
29
2
11
8
9
10
9/14/15 1:51 PM