Connecting To The Control Panel; Connecting A Computer; Mounting On A Rack Conforming To Eia Standards - Pioneer DJM-400 Manual De Instrucciones

Connecting to the control panel

Microphones
Headphones
3
1 MIC 1 terminal (page 9)
Connects a microphone here.
2 MIC 2 terminal (page 9)
Connects a microphone here.
3 PHONES terminal (page 9)
Connect headphones here.

Connecting a computer

Use a commercially available USB cable no longer than 3 meters in
length.
CH-2 CH-1
LINE CD SIGNAL PHONO/LINE CD
GND
L L
RETURN
R
LINE PHONO
R R
R (TRS) L R (TRS) L R
R BOOTH ZONE SEND
Computer
There is no need to install dedicated driver software.
1 2
HEADPHON
L
(MONO)
L
USB
Mounting on a rack conforming to
EIA standards
The mount holes on the sides of this unit's control panel are suited for
the 4U size of 19" EIA standard racks. Leave enough space behind the
terminal panel to connect the terminals.
! Secure this unit with screws (not supplied) matching the rack.
! Do not install this unit directly above a power amplifier. Heat radiat-
ing from the power amplifier may damage this unit. Also, noise (hum
noise, etc.) may be generated.
! When transporting this unit, remove it from the rack. Transporting
this unit without removing it from the rack may damage this unit.
! If you transport this unit without removing it from the rack, make
sure vibration or shock is not applied to this unit.
9 9
5 5
2 2
0 0
- - 2 2
- - 4 4
- - 7 7
- - 1 1 0 0
- - 1 1 5 5
CUE
CUE
7
En