Klarstein 10032915 Manual De Uso página 52

Caring for the Dishwasher
• The control panel can be cleaned by using a lightly dampened cloth and dry thoroughly.
• The exterior use a good appliance polish wax.
• Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
• To clean the edge around the door, you should use only a soft warm,
• damp cloth. To avoid penetration of water into the door lock and electrical components, do not use a spray
cleaner of any kind.
Protect against Freezing
please take frost protection measures on dishwasher in winter. Each time after washing cycles, please operate
as follows:
1. Cut off electrical power to the dishwasher.
2. Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve. (Use a pan to catch the water)
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to use up water in sump.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals
will clog the spray arm jets and bearings.
To remove the upper spray arm, hold the nut, rotate the arm clockwise to
remove it. To remove the lower spray arm, pull out the spray arm upward.
Wash the arms in soapy and warm water and use a soft brush to clean the
jets. Replace them after rinsing them thoroughly.
How to keep your Dishwasher in Shape
• After every wash, turn off the water supply to the appliance and leave the door slightly open so that mois-
ture and odors are not trapped inside.
• Before cleaning or performing maintenance, always remove the plug from the socket.
• To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products.
Only use a cloth with warm soapy water. To remove spots or stains from the surface of the interior, use a
cloth dampened with water with a little vinegar, or a cleaning product made specifically for dishwashers.
• It is recommend that you run a wash cycle with the dishwasher empty and then remove the plug from the
• socket, turn off the water supply and leave the door of the appliance slightly open. This will help the door
• seals to ast longer and prevent odours from forming within the appliance.
• If the appliance must be moved, try to keep it in the vertical position. If absolutely necessary, it can be
• positioned on its back.
• One of the factors that cause odors to form in the dishwasher is food that remains trapped in the seals.
• Periodic cleaning with a damp sponge will prevent this from occurring.
52