Dust Extraction - Festool HK 55 EQ Manual De Instrucciones

CAUTION
Hot and sharp tools
Risk of injury

Do not use insert tools that are blunt or defec-
tive.

Wear protective gloves.
5
5-11
5-10
5-9
5-8
5 - 1
5 - 2
5 - 3
5 - 4
5 - 5
5-6
5-7

Swivel saw to 0° position before replacing the
saw blade and set maximum cutting depth.

Position saw on motor cover when replacing [5-
2].

Turn lever [5-4] as far as stop.

Open the screw [5-10] using the Allen key [5-3].

Hold the pendulum guard open [5-11] only with
retractor lever [5-5].

Remove saw blade [5-9].

Insert new saw blade.
The direction of rotation of the saw blade
[5-7] and saw [5-6] must match.

Insert the outer flange [5-8] so that the pin en-
gages in the recess on the inner flange.

Release retractor lever [5-5] and allow the pen-
dulum guard to swivel back [5-11] to its final
position.

Tighten screw [5-10].

Reposition lever [5-4].

Dust extraction

WARNING
Dust hazard

Dust can be hazardous to health. Always work
with a dust extractor.

Always read applicable national regulations be-
fore extracting hazardous dust.
Festool mobile dust extractor
A Festool mobile dust extractor with an extractor
hose diameter of 27 mm or 36 mm (36 mm is rec-
ommended due to the reduced risk of clogging) can
be connected to the extractor connector [1-10] at
the elbow.
– Static charge may occur if an anti-static suction
hose is not used. The user may suffer an electric
shock.
Independent extraction

Secure the connection piece [6-2] of the dust
collection bag [6-3] at the extractor connector
with a clockwise rotation [6-1].

To empty remove the connection piece [6-2]of
the dust collection bag [6-3] from the extractor
connector with an anti-clockwise rotation [6-1].
15