dirna Bergstrom bycool COMPACT 1.4 Instrucciones De Montaje página 17

COMPACT 1.4
Position the front on the front studs with (1) M6
11
wide-flanged washer and (1) M6 nut on each
stud. Tighten the nuts until the channelling
equipment comes into contact with the upper
foam in the unit.
Important: The rubber ductings should
come to a stop against the foam rubber in
order to prevent leakages of air.
Ø 6 flat washer
Original
edgeband
Cabin roof
Upholstery
Original screw
12 Tighten nut mentiones under point 9 until it
touches upper surface of front.
13 Present console and centre Compact until
original screws coincide with their original
position.
Ø 20 x Ø 7 x 3 rubber washer
9
A
M6 nut
M6 nut
M6 stud
Console
Air conditioning for vehicles
11
EPDM joint
Adjust canalisation systems against base joint
Rubber ductings
13
17
EN
Diagram A
Front