Gas Connection; Connection Of Fume Exhaust Vent - Angelo Po 10NCP1IA Manual De Uso

Important
Those authorised to carry out the connection
operation must have experience acquired
and certifi ed in the specifi c sector, in accord-
ance with current legislation in the appli-
ance's installation country.
The connection must make to the proper
standards and must comply with all the rel-
evant regulations and legislation.
When the connection has been made, before
making the appliance operational, do a gen-
eral inspection to make sure there are no gas
leaks.
To make the connection, connect the mains
line to the appliance's connection pipe, fi tting
a shut-off tap (A) , to allow the gas supply to be
cut off when necessary.
Important
The tap (A), not supplied with the appliance,
must be installed in an easily accessible posi-
tion and its status (on or off ) must be obvious
at a glance.
Important
Make the connection in compliance with the
relevant legal requirements, using appro-
priate and recommended materials.
Position the appliance
1)
underneath the hood (A)
(see diagram).
Important
The gas supply tap (A) must
open automatically when
the fan of the extraction sy-
stem is switched on.
3329640_inst_GB

GAS CONNECTION

CONNECTION OF FUME EXHAUST VENT

A
A
Important
The gas supply pipe must comply with the
national requirements in force and must be
periodically examined and replaced if neces-
sary.
Connecting to a fan extractor hood
To carry out this operation, proceed as follows.
A
- 11 -
GB
ENGLISH