Assembly Preparation / Electrical Connection; Connected Loads - GUTMANN VIENTO Instrucciones De Montaje

Ocultar thumbs Ver también para VIENTO:
Tabla de contenido

Publicidad

EN

Assembly preparation / Electrical connection

WARNING AGAINST ELECTRICAL TENSION !
THERE IS DANGER TO LIFE !
There are energised parts near this symbol. Covers marked with this symbol may
only be removed by an authorised electrician.
The electrical connection may only be carried out by an authorised specialist!
The statutory regulations and connection conditions of the local electrical supply com-
pany must be observed in full.
When the device is connected, a device must be provided which makes it possible to dis-
connect the device from the mains with an opening width of at least 3 mm all poles using
a contact. LS switches, fuses and contactors are regarded as suitable disconnecting de-
vices. When connecting and repairing the device, disconnect it from the power supply u-
sing one of these devices.
The protective conductor must be long enough so that if the strain relief fails, it will only
be subjected to tensile stress after the current-carrying cores of the connecting cable.
The excess cable length must be pulled out of the installation area below the device.
Please make sure that the mains voltage is the same as on the nameplate.
Complete protection against accidental contact must be ensured by installation.
Attention: Incorrect connection can lead to destruction of the power electronics.
The device is only approved for permanent installation. It must not be connected with a
safety plug.

Connected loads

Cooker hob mains voltage:
1N~ 220-240V / 32A , 50/60Hz
2N~ 380-415V / 16A , 50/60Hz
Connecting cable available at the factory
The hob is equipped with a temperature-resistant connection cable at the factory.
Damaged lines may only be replaced by the manufacturer or his customer service.
24
Observe EN 60 335-2-6 / 2016-02 !

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2900 ml

Tabla de contenido